Quantcast
Viewing all articles
Browse latest Browse all 1583

RZ/A1L, mapping SDRAM, LCD and Ethernet signals without conflict for 208 pin device

Hi,

Im using RZ/A1L in our design. My application requires Ethernet, SDRAM and LCD (TFT). When I map the pins for Ethernet and LCD, its conflicting. I would like to use non-BGA package, the max pin possible in RZ/A1L is 208pin. However, it looks to me, i cant configure 208 pin device for Ethernet, LCD and SDRAM bus signals. I have the conflict on LCD_D0 to LCD_D7 signals, where as there are no issues in LCD8 to LCD23.

Even i tried to configure the LCD in 565 mode, loosing 8 bit of LCD data, however in this mode also, there is no way to use 16 bit as LCD_D8 to LCD_D23, the LCD controller is always mapping to LCD_D0 to LCD_15, and leaving to gnd the signals LCD_D16 to LCD_23. It would have been better the LCD_D0 to LCD_D7 were mirrored on unused signal LCD_D16 to LCD_D23. This would have enabled RZ/A1L a better flexible micro.

Is there anyway to map RZ/A1L for SDRAM, Ethernet and LCD without conflict? Kindly suggest  

 

Thanks


Viewing all articles
Browse latest Browse all 1583

Trending Articles