Hi,
I have a custom RZA1H board designed with dual SNOR flash (Spansion S25FL512SAGBHI310) device. Programming the bootloader using Seggar JLink Lite V634h was fine. The Renesas QSPI Bootloader code was modified to configure the SPBIO pins accordingly.
Downloading however fails for the application image generated by e2studio. It looks like the JLink tool times out while erasing the devices. The error message is: "block verification error".
I understand the bootloader is sent on one-bit mode to the first device. Having the bootloader reconfigure the system to Dual mode operation and enable Read Burst Cache, the application image is downloaded to both devices. Not sure if it is done on one-bit or quad bits.
My test program can write data to both device but over single lane only.
Anyone came across similar issues?
Many thanks
Regards
EsKay
