my RSK+ RZT2M board is good at first，
Reference documents rzt2m-getting-started-flexible-software-package.pdf
Figure 2: Boot MODE SW Setting Description SW4.1 ON 16-bit bus boot mode (NOR Flash) SW4.2 OFF SW4.3 ON SW4.4 ON JTAG Authentication by Hash is disabled. SW4.5 ON ATCM 0 wait Valid for CPU operating frequency equal to or less than 400MHz
final，Run the Blinky Project，The LEDs on the board LED 0~1 should now be blinking.
but，
When I modify the SW4 switch and FSP (xspi0 X1 boot mode) many times, in order that the program can maintained
then，the debug cant run to hal_entry() anymore。
It may be related to my attempt to download hex files using j-flash Lite. When I download hex files using j-flash Lite, I am prompted to update the JLINK firmware，i dont know
Finally, how can I restore to the factory state
