Hello,
We are using RZG2UL based custom board with AR8031 Gigabit Ethernet PHY with Linux 3.0.3 BSP.
Ethernet is configured and working properly but when calculating throughput for 1Gbps speed using iperf3 utility we are getting low throughput.
Throughput while sending is 535Mbps and while receiving is 419Mbps.
iperf3 -s is the command used at server side and iperf3 -c <server ip> on client side.
How can we increase the throughput or is there any other utility to check throughput?
Regards,